सुदुरपश्चिम प्रदेश, सब इन्जिनियर (पाँचौँ तह)— २०८३/०८/०५
1. The plinth area of a building does not includes:
-
(A) area of the walls at the floor level
-
(B) internal shaft for sanitary installations up to 2 sq.m. in area
-
(C) lift and wall including landing
-
(D) area of cantilevered porch ✓
2. The damp proof course (D.P.C.) of a specified thickness is measured in:
-
(A) Cubic meters
-
(B) Square meters ✓
-
(C) Meters
-
(D) None of these
3. The chairman of rate fixation committee in district level is:
-
(A) CDO ✓
-
(B) Chairman of DCC
-
(C) LDO
-
(D) SP
4. What does a technical sanction primarily guarantee?
-
(A) Funds are available in the current financial budget
-
(B) The structural soundness and correct rates of the project design ✓
-
(C) Administrative priority of the building
-
(D) Selection of the contractor
5. According to public procurement act, 2063 for the procurement of works the bids security amount mentioned as:
-
(A) 1 to 2 percent of estimate cost
-
(B) 2 to 3 percent of estimate cost ✓
-
(C) 3 to 4 percent of estimate cost
-
(D) 4 to 5 percent of estimate cost
6. Tender document does not contain:
-
(A) Tender form
-
(B) Bill of quantities
-
(C) Amount of earnest money ✓
-
(D) Unit rates.
7. Which one is not a project scheduling method?
-
(A) Bar chart
-
(B) Network analysis
-
(C) Rate analysis ✓
-
(D) Critical path method
8. Slack time refers to an:
-
(A) event ✓
-
(b) activity
-
(C) both a and b
-
(D) none of the above
9. प्रदेश निजामती सेवामा नियुक्त कर्मचारीले नियुक्ति भएको कति समयभित्र व्यक्तिगत विवरण (सिटरोल) पेश गर्नुपर्छ?
-
(A) १५ दिनभित्र ✓
-
(B) १ महिनाभित्र
-
(C) ३ महिनाभित्र
-
(D) ६ महिनाभित्र
10. स्थानीय सरकार सञ्चालन ऐन, २०७४ बमोजिम भवन निर्माणका लागि अनुमती दिँदा भवनको निर्माणबाट संधियार कसैलाई मर्का पर्ने भए कति दिनभित्र उजुरी गर्न सकिन्छ?
-
(A) ७ दिनभित्र
-
(B) १५ दिनभित्र ✓
-
(C) ३५ दिनभित्र
-
(D) ६० दिनभित्र
11. In surveying when curvature of earth is taken into consideration then that type is called as:
-
(A) Chain surveying
-
(B) Geodetic surveying ✓
-
(C) Plane surveying
-
(D) Contouring
12. In levelling operation:
-
(A) when the instrument is being shifted, the staff must not be moved
-
(B) when the staff is being carried forward, the instrument must remain stationary
-
(C) both (a) and (b) ✓
-
(D) neither (a) nor (b)
13. For a tachometer the additive and multiplying constants are respectively:
-
(A) 0 and 100 ✓
-
(B) 100 and 0
-
(C) 0 and 0
-
(D) 100 and 100
14. In Plane Table Surveying, the method used for locating distant or inaccessible points is:
-
(A) Radiation
-
(B) Intersection ✓
-
(C) Traversing
-
(D) Resection
15. The argillaceous rocks have their principal constituent as:
-
(A) Lime
-
(B) Clay ✓
-
(C) Sand
-
(D) None of the above
16. Ultimate strength to cement is provided by:
-
(A) Tri-calcium silicate ✓
-
(B) Di-calcium silicate
-
(C) Tri-calcium aluminate
-
(D) Tetra calcium alumino ferrite
17. The most important tool in brick laying for lifting and spreading mortar and for forming joints is:
-
(A) square
-
(B) scotch
-
(C) trowel ✓
-
(D) bolster
18. The principal volatile vehicle added to paint to increase flow, consistency and workability is called a:
-
(A) Base
-
(B) Binder
-
(C) Thinner ✓
-
(D) Drier
19. Which of the following gives Modulus of Rigidity?
-
(A) ratio of linear stress to linear strain
-
(B) ratio of shear stress to shear strain ✓
-
(C) ratio of lateral strain to longitudinal strain
-
(D) ratio of normal stress to normal strain
20. Hooke's law holds good up to:
-
(A) Yield point
-
(B) Plastic limit
-
(C) Elastic limit ✓
-
(D) Breaking point
21. When a body is subjected to two equal and opposite pull forces along its longitudinal axis, the stress produced is called:
-
(A) Shear stress
-
(B) Tensile stress ✓
-
(C) Compressive stress
-
(D) Bending stress
22. The property of a fluid by virtue of which it offers resistance to the movement of one layer over another adjacent layer is:
-
(A) Surface tension
-
(B) Capillarity
-
(C) Viscosity ✓
-
(D) Compressibility
23. Bernoulli's equation assumes that:
-
(A) fluid is non-viscous
-
(B) fluid is homogeneous
-
(C) flow is along the stream line
-
(D) all of the above ✓
24. When water flows over a rectangular suppressed weir, the negative pressure created beneath the nappe:
-
(A) increases the discharge ✓
-
(B) decreases the discharge
-
(C) does not affect the discharge
-
(D) divides the discharge
25. Pressure head is given by:
-
(A) P/w ✓
-
(B) Z
-
(C) V/2g
-
(D) All of the above
26. The relationship between void ratio (e) and porosity ratio (n) is:
-
(A) n=e/(1-e)
-
(B) e=n/(1-n) ✓
-
(C) e=(1+n)/(1-e)
-
(D) n=(1+e)/(1-e)
27. The rise of water table below the foundation influences the bearing capacity of soil mainly by reducing:
-
(A) Cohesion and effective angle of shearing resistance
-
(B) Cohesion and effective unit weight of soil
-
(C) Effective unit weight of soil and effective angle of shearing resistance
-
(D) Effective angle of shearing resistance
28. Total lateral earth pressure is proportional to:
-
(A) Depth of soil
-
(B) Square of depth of soil ✓
-
(C) Angle of internal friction of soil
-
(D) None of the above
29. According to the assumptions in Terzaghi's analysis, the soil is:
-
(A) Homogeneous and Isotropic ✓
-
(B) Non homogeneous
-
(C) None of the mentioned
-
(D) All of the mentioned
30. The limiting moment of resistance (Mu, lim) for a balanced section reinforced with Fe 415 steel is approximately:
-
(A) 0.149fck bd2
-
(B) 0.138fck bd2 ✓
-
(C) 0.133fck bd2
-
(D) 0.36fck bd2
31. In the actual beam, bending moment at any section in a conjugate beam gives:
-
(A) slope
-
(B) curvature
-
(C) deflection ✓
-
(D) bending moment
32. The diameter of longitudinal bars of a column should never be less than:
-
(A) 6 mm
-
(B) 8 mm
-
(C) 10 mm
-
(D) 12 mm ✓
33. The main reinforcement in RCC cantilever beams is placed at:
-
(A) Top fibre ✓
-
(B) Side fibre
-
(C) Bottom fibre
-
(D) Top and bottom fibres
34. The bearing capacity of a water logged soil can be improved by:
-
(A) compacting the soil
-
(B) draining the soil ✓
-
(C) increasing the depth of foundation
-
(D) grouting
35. The D.P.C. is provided at:
-
(A) The plinth level ✓
-
(B) The window sill level
-
(C) Anywhere in the wall
-
(D) below the topmost floor level
36. What is the standard nominal mix ratio for M20 grade concrete as per standard field practice?
-
(A) 1:3:6
-
(B) 1:2:4
-
(C) 1:1.5:3 ✓
-
(D) 1:1:2
37. Dado paneling is usually provided in:
-
(A) Dining halls
-
(B) Bathrooms ✓
-
(C) Sleeping rooms
-
(D) Roofs
38. Surface water is obtained from:
-
(A) Well
-
(B) Spring
-
(C) Artesian well
-
(D) Rain ✓
39. Self-cleansing velocity is:
-
(A) velocity at dry weather flow
-
(B) velocity of water at flushing
-
(C) velocity at which no accumulation remains in the drains ✓
-
(D) velocity of water in a pressure filter
40. A sewer which receives discharge from two or more than two sewer is called:
-
(A) trunk sewer ✓
-
(B) main sewer
-
(C) multi sewer
-
(D) interceptor sewer
41. Surge tank are used:
-
(A) for storage water
-
(B) to increase the velocity in a pipeline
-
(C) as overflow valves
-
(D) to guard against water hammer ✓
42. Which is not an advantage of drip irrigation system among the following?
-
(A) Shallow root depth ✓
-
(B) Water supply at optimum level
-
(C) Less requirement of irrigation water
-
(D) Nutrient preservation
43. The amount of irrigation water required to meet evapotranspiration need of crop during its full growth is called:
-
(A) effective rainfall
-
(B) consumptive use
-
(C) consumptive irrigation requirement ✓
-
(D) net irrigation requirement
44. Time of concentration is:
-
(A) the time taken for precipitation
-
(B) duration of rainfall
-
(C) time taken for all the ran off to reach the drain
-
(D) time taken for the storm water to travel from the most remote point to the drain. ✓
45. The operation during the infiltration of water below the ground surface is:
-
(A) adsorption ✓
-
(B) absorption
-
(C) ozonation
-
(D) sedimentation
46. Cross-slope in the road is provided for:
-
(A) Effective drainage ✓
-
(B) Counteracting the centrifugal force
-
(C) Having proper sight distance
-
(D) All of the above
47. If the elevations along a road increase, the slope of the road along the longitudinal direction is known as:
-
(A) gradient
-
(B) grade
-
(C) positive gradient ✓
-
(D) negative gradient
48. The terrain may be classify as rolling terrain if the slope of the land:
-
(A) upto 10%
-
(B) between 10% and 25% ✓
-
(C) between 25% and 60%
-
(D) more than 60%
49. Flexible pavement distributes the wheel load:
-
(A) directly to sub-grade
-
(B) through structural action
-
(C) through a set of layers to the sub-grade ✓
-
(D) none of the above
50. The most reliable estimate is:
-
(A) Detailed estimate ✓
-
(B) Preliminary estimate
-
(C) Plinth area estimate
-
(D) Cube rate estimate